%ARP-E-ARPTBL: ARP Table Overflow, aggregated - Constantly appearing

[Avensiscomic30]

Hi,

There are numerous alerts on the Cisco SG300 Management Switch. This is in Layer 3 mode.

The alert is:  %ARP-E-ARPTBL: ARP Table Overflow, aggregated 

I cannot add an additional Static route either unfortunately with the following alert message:

%IPROUTETABLE-A-ROUTETABLEOVERFLOW: IP routing table overflow: failed to add route address

Is there some limitation on the switch?

Thanks in advance.

Sam

[ifradsham]

Try changing the maximum entries under routing resources (TCAM utilization) from Use Default to some higher number in the user defined option.  I believe the default is 128.

[robson.sinobras]

Worked for me, thanks!