Switches - Small Business

I have 8 ACLs on a CBS350-24XS with firmware 3.5.0.24. Total number of ACEs across all ACLs is 360. About 244 of these ACEs are in ACLs which are active (bound to VLANs). Status and Statistics -> Hardware Resources Utilization tells me that 244 out o...

Hi all,Can someone please explain how to use the SSL HTTPS certificate on a local connection to my CBS250 switch?Please explain it simple (noob)Thanks.

Hi All, We want to upgrade our Cisco SF-300 24P 10/100 POE Managed Switch to SF-350 24P 10/100. Can anyone please explain what the procedure is like? Is there an option to backup config from the current switch and just dump in to the new one? Or do w...

Hello,I have been looking for several hours for the parameter to configure SMTP on a cisco SG350-28MP switch.I can't find anything, is it available?

Hello,I am in the process of configuring all the SMTP on the hardware. I can't find anything for the CISCO SG350-28MP.I haven't found anything on the internet about this.Does it not exist?

Hello everyone,I am in the process of configuring a Cisco RV345 router. I'm at the SMTP configuration stage but I'm totally blocked.I put :SMTP Server: smtp.gmail.com (e.g.: 1.2.3.4 or abc.com or fe80::10)SMTP Port: 465 or 587 (Range: 1-65535 Default...

Hi i am encountering an error on a Cisco CBS350 switch, the error message says: '%DHCP-W-MAXALLOC: DHCP Server has reached the maximal number of allocated hosts. Attempting to free entries by aging property for IP 192.168.100.112.' I have checked the...

Hello all,i have a SX550x All is ok on 10gbe, but i recently connect a 2.5gbe card and i see only 1gbe...My question is stupid but is it normal? If yes, i need another swith compatible 1, 2.5, 5 and 10gbe?thx a lot

On Cisco CBS-350 switch, when attempting to remap DSCP 46 (EF) to 18 (AF21) on the Out-of-Profile DSCP mapping, a following error occurs:"The re-mapped dscp must be mapped to the same queue as the mapped dscp."The manual for the switch mentions that ...

Hi,have trouble with an CBS350 stack and some WLAN APs.According to the log, the port fi2/0/42 was "suspended by acl-deny".Two questions:- Why did the firmware suspend the port, even where are no errors logged?- Why did the firmware suspend the port,...

Good morning,I would like to buy two CISCO switches, the SG350-10MP and the SG350-28MP.When I look, I see different versions such as V02, V03, V05, V06 for example. I would like to know what the differences are between the different versions mentione...

Ladies/Gents:I need to change the management IP of my 9300. Discovered I have a C1000 connected on the network with duplicate IP address. Should start out by asking if I can do this via the CLI interface on the switch web GUI or can this only be acco...

I just deployed a CBS250-16P-2G in an office environment and the (what I am pretty sure is) transformer noise is pretty bad. Its a continuous high pitched buzz and the users near it are being driven crazy. I am probably going to seek replacement, but...

The 3850 has had the following commands completed:install remove inactiveThen going to the desktop hosting the Solarwinds TFTP server.I was able to ping the switch from the desktop.When I start the remove function, I get the following:SUCCESS: No ext...

Hi All,I am trying to configure a script for saving the running-config to a fileserver for backup purposes. So, it must be able to run without user interaction and that a user must not be logged on the specific server where the script is running. I h...