Switches - Small Business

Hi,I´ve noticed a strange behaviour on my new SG500-28 stack ( 2 devices ). During node reboot ( console reload slot 1 / 2 ) the switch ports of the booting switch stay up ... I mean the device on the other side sees a physical link ...Can someone pl...

Hi, i have two switch SG300-10 that need to be interconnect togheter with a simple redundant "cable fail safe" configuration.My idea is use the two uplink copper port of the first switch, connected to the two uplink copper port of the second switch.C...

Hallo Community,i have a big problem with my SG300 switch. I would like to implement Radius authentification for SSH Access via Radius. The Radius server is a Windows Server 2008 R2 (NPS). The Switch and the Server can communicate.On the radius serve...

i have one cisco switch 350 XG and 6 switches SF 300 and i created Vlan for each swith and than all this switches connect to switch 350 XG i already created Vlan interface for each Vlan. and elso enable IP routing on the mulitlayer switch . but there...

Hey guys, I am starting a very small project and need some assistance if possible. Al of the videos I watch tend to explain things as if the user is already familiar...I am not so please, bear with me.  We have a portion of our staff (about 20%) w...

Try to recover the password on the switch...  was able to get to  switch(boot)> admin-password password but when I try to load the IOS.img (m9100-s2ek9-mz.3.3.lc.bin---> load bootflash:ios.img I got an error. no file found.... Please help.

Hi,can somebody tell me how to configure the stacking of 2 SG350XG so that the current stack master stays stack master?I mean when I reboot or disconnect the current master from power the backup unit becomes master but at the moment this disconnected...

My sg300-28 28 port gigabit managed switch SW version    1.3.0.62Boot version    1.1.0.6 Like to upgrade higher versions 1.3.5. can i update the boot ver and fw version directly to 1.3.5., Also the time taken to reboot the switch.

Hi! I use the SG300 in Layer 3 mode so it routes between VLANs. I have multiple VLANs and want to isolate some of them. E.g. I have VLAN 10 which is 192.168.0.x Therefore I create an ACL and an ACE which shall allow only traffic from the same VLAN, s...

Current version of cisco switch SG300-28 28-Port Gigabit Managed Switch is 1.3.0.62 fw, 1.1.0.6 boot version. I like to upgrade boot version to 1.3.5.58. Can i upgrade the boot version directly to 1.35.58 ? Is there any problem ? Any idea about the t...

Hello, i have some SG500 in a stack.The Stack has Routing enabled and everything works as expected.But now i created a new VLAN10, assigned an IP-adresse and i'm not able to route into this vlan.There is no entry in the routing table. In VLAN10 are 2...

All, I am part of the CUCM TAC team and please bear with me as I do not handle much of the networking/switching aspect and really have no clue when it comes to the switches I am asking about. I've done some research and I can only find documentation ...