Switches - Small Business

Hi, This year we deployed over a hundred Chromebooks in one area of our school for the Gr 7's (1:1 ratio).  Yesterday I found that the Meraki MR32's in that area (I have 3 of them dedicated for that area of the school) were laggy in terms of authenti...

Hi , I have a  SG 200-08 8-Port Gigabit Smart Switch switch. I connected it to dell sonic wall using a trunk port.Each time the power recycled the switch starts but the the tagged vlan 1 become untagged and the communication drops to sonic wall.I che...

Hi All, I have small business switches at roughly 140 sites.  Each of these sites are 192.168.XX.0/24. All switches are in the .230-.239 range. All access points are in the .100-.120 range. Firewalls are .1-.2. Basically I want to block management ac...

Hello, I have a bunch of L2 SG300 switches and one L3 SG300 switch providing a VLAN environment - which all works to my liking. However, I have a number of dial-in users coming into the network and I would like to be able to assign each user to a VLA...

Hello All, I am trying to configure the sg300 switch (set to L3 mode) to provide a wireless network with multiple SSIDs that provide a DHCP assigned address from different scopes depending on what SSID is chosen. I have a Staff, a Guest  and a Regist...

Hi Everyone, I'm very much a beginner with Cisco stuff, so go easy on me :-) I've taken a few courses, but haven't had to apply them in real work stuff (lack of cisco managed switches), so i'm re-learning. I am working as a consultant, and the clien...

Hi,Does anyone know how to configure SNMP on the Cisco SG300 switches? I have the SG300-10P. I am not fully familiar with the new command line interface on this device, it was easy on the IOS but finding it a nightmare on this one.I put the following...

Hello, I have  a Cisco Small Business SF300-48P 10/100 PoE Managed Switch.  After upgrading the firmware and rebooting the switch, all the PoE ports stopped giving power to IP phones connected to them and they changed in Fault Status. Does anyone kno...

I've got a Cisco SG300-20 that I am trying to wipe.  I've performed a factor default.  This clears out the configs, but not the flash.  On other Cisco devices I would use the "format" command, but the SG300 does not appear to have this option.  How d...

This is a question about support of particular functions on the newest available firmware for SG-200 50P 1.4.5.02. Can this switch support following functions regarding port authentication (not in theory but practically): - 802.1X RADIUS MAC authent...

Dear Team, I have 2 no of New switch Cisco 28 Port SG500 L3 Gbps (x2) How to configured both switch in stack please guide step by step with command or share link for reference. please mention stack cable details also (required SFP card or not) Imple...

Release notes mentioning upgrading to boot image 1.4.2.04 before upgrading the to the 1.4.2.firmware: Where would one go to download this?  The only file available is the firmware itself (there is no rfb file for this version).

Hi there, We are new to VLANs and have 6 switches which we are looking to trunk VLANs between 4 SG300-28PP and 2 SG300-48PP switches. We are currently trying to get VLANs working with 2 VLANs to start with but after that would like to be able to do...