Switches - Small Business

I inherited this switch when I took over IT Management for my current employer. I know very little about it. Yesterday I successfully reset the cisco password via serial cable. Now that I can login to the web UI, I see the firmware is quite old. It i...

I have a few SG220 switches with code 1.0.0.19 and ports are show input errors and throttles on ports connected to APs.  I am seeing it impacting wireless connectivity as well connected to Cisco 2602i and 2702i APs running 8.0.121.0. I believe this ...

I have a few SG220 switches with code 1.0.0.19 and ports are show input errors and throttles on ports connected to APs.  I am seeing it impacting wireless connectivity as well connected to Cisco 2602i and 2702i APs running 8.0.121.0. I believe this ...

Hi I am setting up a office which currently has only one  switch, which is 2960x. Knowing that it supports  some of the L3 feature through "Lanbase routing" VDM. I have done the same. Following  settings have already  been done : 1. Loaded the right ...

I have two issues with my SG300-52 switches. I have configured the same VLANs on both of them for availability and redundancy. The switches connect to a router, and clients get IP addresses from a 2k8 DHCP server. My issues are: 1. I get 2 or three ...

I have an sg300-52 switch on which I can access all the vlans but am unable to access the internet. I have attached my configurations below. The default gateway is an interface on my router. I now think that my configurations are not right. May you p...

Hi, I am looking for SFP transceiver module compatible with WS-C2960+24TC-S switch for single mode, 1310nm, upto 20km, 1000Base LC connector. Can anybody suggest? Regards, Pramod

I need to connect the following switches  SG500X-24MPP and SG-300-52MP by considering optical fiber and the MGBLX1. However I get no connection. If I connect the SG-300-52MP and SG-300-28P by considering optical fiber and the MGBLX1 I have no proble...

We have a SG500-52p Managed/Stackable switch that will just disappear from the network.  Can't connect new computers and the web interface can't be found and it can't be pinged.  After a restart all is well again.  Can't find any issues in the log.  ...

We have Corp Office with all of the Company Resources (Mail, web, files) and 30 Employees there all the time, Remote Sales Office A wth 30 People at Most, though maybe 10 Average, and Remote Sales Office B with 10 People and average of maybe 4.  The...

I have a number of SG220 -48 POE Switches (1.0.0.8) where I find a grouping of ports stop working.Example Port 13-16 Ports 37-40I have checked the port status using the CLI and GUI and performed "shut , no shut"I have also checked the spanning-tree s...

Newbie question.  We set up a network a few months ago in our new office with an SG500-28P as the central piece of connecting NW equipment, to which we attached VoIP phones, PCs and printers.  Also attached was a wireless AP, and 2 modems connected t...

I have two servers, both with SSD drives, copying large files using the 10 gb SFP ports on this switch.  However, network performance seems to be poor.  I typically see 1 - 2 gbps of throughput.  What might be some reasons for low throughput?