Switches - Small Business

Hello, Looking to purchase Qty 3 SG300-52MP to replace the switches on my voice network.  In cascade/bridge mode will I be able to do a port mirror on every port on all 3 switches? What I'm looking to do is purchase voice recording software from some...

I've misplaced the rackmount kit that came with my SG 300-20, but can't seem to find anywhere that sells one. Any suggestions where I can get one? Thanks, Jonathon

Hi there,I have three SG500X-24 all nicely connected with MGBSX1 nativily stacked switch1Master, switch2Backup, switch3Slave and fully operational with two VLANs I configured, one for my corporate network and the other one for the customer network (g...

i need to know SF500-48-K9 support only static routing ?

Hi all.I've been scratching my head for quite some time and I'm not sure why my setting is not working.  Nothing really special with my setting, I'd say but again I'm not sure.  I have 2 switches.  one is SWA (SG300-20).  The second one is SWB (Catal...

Hi, I've been trying to stack three switches a SG500-28P a SG500-52P and a SG500X-28P - the SG500s stack fine, however when I added the 500x to the stack, the unit deactivated itself and took itself off the network - not good as it was the core switc...

Hi all. I'm having trouble confighuring and make it work a small businness SG500 with a sfp transceiver. We had two old Catalist 1900 C.They were connected throw their 100BASEFX Port.One of them stop to work.The client buy as replacement an SG500 + c...

Hi guys I'm having difficulty logging into a SG300-28P switch via the the serial console and Gui interface ,so I've reset the switch to default and still cant log in I'm using putty.please id appreciate some helpthanks Razak  

I was looking to use an SG300-20 for layer 3 routing, but I wanted to confirm how it worked in this router mode.1. Will it route by connection between different VLANs configured on different subnets, or do I need to define a default route to an exter...

I have a Cisco SG500-52 (not PoE) switch stacked (2 switches total).The password has been forgotten for the switch.  I have repeatedly attempted to access this switch via the console but I am not getting anything appear in the console window.I powere...

We have a SG300 with a few different subnets on it.  .202.x, .102.x, and .222.x.  For some reason, we can't get traffic to flow from the .202 network to the .222 network.  In other words, if we try to ping 192.168.222.5 from a computer on the .202.x ...

Hi,I am trying to reset to factory default settings a 24port SF500 Cisco Switch. When power is given, FAN Led is on but System Led is permanently blinking. I have tried following the Reset instructions but nothing happens when keeping the reset butto...