Switches - Small Business

I have two SG500-52P and are both connected through a TRUNK port (native vlan 11 untagged, tagged vlans 4-8). I tried to reset and reconfigure both switches but the PCs connected to the access ports in the same VLAN but in different switches can't pi...

Hello All, I have several 100 SG300 series switches. With the latest update to 1.4.1.3I am having several problems. 1) anywhere from a few hours to a few days, the switches Web GUI (HTTP and HTTPS)stop working. Sometimes also ssh.  Sometimes the swit...

Hi All,I would like to know whether stacking with different stack port speeds is possible and supported. I own two SG500-52P switches which are already stacked using SFP-H10GB-CU1M modules.I know that between two SG500 switches the max speed can only...

Hello all , Can I make a stacking configuration between the 2 Cisco Small business SG300 52P to replicate the configuration and working as a one logical switch ?

I just downloaded LAN BASE WITH WEB BASED DEV MGR  c2960-lanbasek9-tar.122-55.SE10.tar and loaded it into the flash. Then pointed the boot to it in the subdirectory. dir flash:Directory of flash:/     2  -rwx        1980  Feb 28 1993 16:02:22 -08:00 ...

Hello, I have Cisco Small Business SF300 switch. CLI is more or less similar to IOS, but I can't seem to figure out how to PIPE the output of the command like in IOS: "show log | i fa48". I was wondering if the software on SF300 switches completely l...

Hii.. i am unable to access the subjected switch through console ,i have tried all the possible baud rate and different console cables as well . Please let me know is there any way to solve the issue . Regards , Jawhar.

Does the usage of the 10G ports in the SG500X & SG500XG series require the purchase of licenses per port? Thanks

Hi, Today I thought it would be a good idea to configure my switch to pick up time from my PDC. On my PDC I am running Meinberg NTP software. After some reading I went ahead with unicast. Running wireshark I seen something puzzling. NTP Version 4, c...

How to do copy running-config startup config via snmp sf-300?

I noticed this error on the Flash Memory Log of my SG500 switch stack however i am unable to locate what it means. Can anyone help? %SYSLOG-F-OSFATAL: RESMNGP_unlock_cdb: wrong context for releasing cdb. ***** FATAL ERROR *****  Reporting Task: PVNT...

Hello All,I have some doubt on STP reconfiguration if Root port is down ...Can any one help...?As per my understanding, if any port is down due to any reason, the corresponding bridge shall sends a TCN to the root bridge through the root port.Lets sa...

Hello, may someone can help me. I'm struggeling since 3 days with our VLAN configuration. I don't know where is my error in reasing. Attached is out networktopolgy. Problem: I've no connection to the WLAN APs on Switch 1 and 4. WLAN on Switch 2 (whe...

Hi All, Hope you all doing well. I have small query with Cisco 2960 switch IOS. We are using A end WS-C2960-24TC-S switch with OS "c2960-lanlitek9-mz.122-55.SE5.bin". on gig port of the switch Gi 0/1 and Gi 0/2 we are not able to set port setting for...