Switches - Small Business

I have a question about the SG100D switches series. My network is as following.It starts with a Glasfiber modem --> Draytek Vigor modem. In the modem I have plugged in 3 Cisco SG100D switches, two of them with 5 ports and one of them with 8 ports.One...

I have a Cisco SG300-28P Managed Switch.  After repeated attempts to reset the unit, I discovered that the reset switch had broken.  There were two small pieces that appear to be an internal piece (the part that shorts the pins) and what appears to b...

I stupidly wrote a config to startup that meant I have no access to the config anymore. I tried factory resetting the node by using the physical button on the front - Holding it in for three seconds until the lights flash, then keeping it held in for...

Below Case 636613351 Owner on Cisco Side told me that the MGBSX1 is no longer supported and the documentation is incorrect !CISCO.COM ID:manfred@edv24.atSUPPORT CASE:636613351SUPPORT CASE TITLE:AU-SG220 SFP MGBSX1 compatibility issuesSEVERITY:3STATUS...

OK, clearly I am missing something, but this is my first time using both VLANs and Voice. I have read so much documentation that my eyes are glazing over. Scenario: Cisco SG220-50P feeding a Sonicwall TZ600 firewall and then out to the internet throu...

I'm having problems with my network. We use a single SG102-24 Cisco switch with about 16 ports utilized. The entire network is wired with CAT6 cables. One computer was constantly unable to save files across the network to either of 2 Ready NAS hard d...

I recently setup a small domain for my business and when trying to access the web interface for the SG200 from a client that is in the domain, the switch configuration website has the standard blue background and two input fields, but I can't get any...

So maybe I'm completely missing something but I am unable to figure out how to restore my backed-up configuration file to my switch.The SG-200 series doesn't support FTP or TFTP nor does it have a console port and from what I can see, the web GUI onl...

Hello,I have an SG200-08 and can't get NTP to work.  The relevant lines of my configuration are below:sntp client mode unicastsntp unicast client poll-interval 16sntp server pool.ntp.org enableclock summer-time recurring USA zone EDTclock timezone -5...

hello ??can anyone guide that what is the trunk configuration between SMB and 3850.I also need to configure voice and data vlans .

Hello, I edited this post because my question have changed a lot.Question (theorical question)Let's say I have two vlans. On each port of my switch, I have two devices. Device 1 is on vlan 10 and device 2 is on vlan 20.Device 1 is able to emit tagged...

I need to install a SF100-24 switch into 1RU of a 19 inch rack. I do not have the rack mounting ears as this switch resides on a table.Does anyone know where I can obtain some SF 100-24 ears at? I suspect they will have to be about four inches in len...