Switches - Small Business

Hi Experts,Need your help, advise and support to fix the below issue in bringing our networkJust extended our intranet buildings with Fiber Optic Connectivity with the Following ComponentsData Center Building1. SG2000 - CISCO2. 24 port LIU - MOLEX3. ...

Hi, i recently did firmware upgrade in sf300 8port manged switch from version 1.0.0.7 to 1.3.0.62. Upgradation was cool and the device started booting with new image without any concern. One fine day i identified that interface VLAN configuration cha...

I have two SF300's I'm working with, one is a 24 port the other is an 8 port.My situation is I have location A in one part of town and Location B in another part of town, the two locations are connected via Fiber. Location A (8 Port Switch) has 3 dif...

Hello,I have two Cisco SG300 52P Managed switches, switch A and switch B. I ran out of ports on "switch A" and "switch B" is not currently in use. I would like to expand "switch A" onto "switch B" so that I can have more ports available. Both switche...

Hi,My problem is that all is working on the network except the phone (VOIP) we have 3 phones (Aastra 6755i) plug on the Cisco SG200. But all of them show on screen "DHCP waiting IP".The network is as follow :pro-box (livebox pro "internet") > cisco S...

I have configured several NTP servers to pull time from, but the status always shows that the host is down. I have confirmed with several internal servers that they can reach the NTP servers, but the switch doesn't seem to be able to pull time inform...

I'm having an issue getting my SG300-10 into Layer-3 mode.  I had it in Layer-3 mode under version 1.3.7.18, performed a factory reset by holding down the hard-reset button for 10 seconds.  Updated boot loader to 1.3.5.06 and SW Firmware to 1.4.0.88....

Hi,Would it be possible to stack SG500X and SG500XG together? Best Regards Lasse

Can i use SFP module- 1000BASE-SX on Cisco SG92 - 24 Port Unmanaged Switch?

Hello, I have several SG200-50 50-Port Gigabit Smart Switch, after update to Firmware 1.4.0.88 and Boot 1.3.5.06 save icon always blinks after reboot. Thanks.

Hello all, I've just purchased an SG200-08 port switch that I'd like to deliver 2 POE ports.Is the SG200-08 (not 08P) supposed to work as a PSE for other POE PDs? Additionally, is it anywhere documented which type of POE Input voltage is needed for t...