Switches - Small Business

Hi, I want to upgarde a Cisco Catalyst 3750G 24T because I can't see the web interface.I checked the documentation and see a lot of videos on the net.I downloaded the new firmware c3750-ipbasek9-mz.122-55.SE9.binI downloaded a tftp software and putte...

Hi All, We've got a 7 site business which has from 2 to 6 SG300-28P switches (depending on size) at each site with a mixture of firmware versions. We have one main Layer 3 switch at each site which is the gateway for the voice and wifi VLAN's. Recent...

I have an SF200-24P running FW 1.2.7.76 and boot 1.1.0.6. I wanted to update the firmware in hopes it would help with a weird problem I'm having with a UC320 phone system so I downloaded from Cisco Sx200_FW_Boot_1.4.0.88.zip. The instructions say if...

Have created a stack with a SG500-52P 52-Port Gigabit PoE Stackable Managed Switch and a SG500-28P 28-Port Gigabit PoE Stackable Managed Switch. All seems fine, but my query is the SG500-52P 52-Port Gigabit PoE Stackable Managed Switch is showing has...

Please direct me to a thread that may have answered this and my apologies if I did not search hard enough. I have an SG300-10 and whether in Switch L2 or Router L3 mode (ie set system mode router) I get Unrecognized Command when I run ip router. I do...

Dears...I am new in Cisco, I have a good knowledge in Mikrotik and trying now to work with CiscoI have a Cisco 3560G catalyst 24 ports + 4 SFP portswhat I need is to make groups of ports where in each group the ports can communicate withe each other ...

Hello,I've the SG300 configured in L3 mode, with 5 VLANs each having its own DHCP pool. Everything works as expected. However, my QNAP TS419-PII is not able to pull IP address on both of it's NICs. Note that if I move the DHCP to my RV042 router, IPs...

I am looking for 5 port and 8 port gigabit unmanaged switches in Cisco. Please provide the BoM for the same. As per my understanding the following switches can suffice the requirement (SG100D-05 and SG100D-080) however I am not sure about the DC powe...

Dear All, I need some advices and.. help also I want to limit the bandwidth of my users for internet e.g only 1kbps for each user for internet, but not for local network. And there are some IP address, for which I do not want to create any limitation...

Hello, I am trying to set up a basic home network. I am currently starting with just 1 PC attached to this switch (SF300-08) and 1 ARRIS TM602A modem provided by my ISP. When I connect my PC directly to the ARRIS TM602A, I receive an IP address and c...

 Hello,We have recently purchased an asterisk based IP PBX, it is hosted in-house which uses Grandstream IP GXP1405 Phones.  We have configured and installed. we are able to receive calls and dial out.  Unfortunately our infrastructure was not up to ...

I have the following setup:- A Cisco EPC3928 cable modem router, with ip 192.168.178.1, connected to the internet- A Cisco SG300-10 connected on GE9 with the Cisco EPC3928 on port 1This is my configuration of the SG300:-------------------------------...

In Bangladesh, someone from Cisco has said that "MGBSX1" transceiver for "SG300-28SFP-K9-UK"  is not available right now though I have not find out this kind of eol in the Cisco Web portal.Can somebody suggest me alternative transceiver and ensure me...