Switches - Small Business

I have SG300 Switch running on L3 mode. I can`t assign IP to VLANS .when I try it through CLI or GUI switch crashes and needs reboot.

Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about Voice VLAN on Small Business switches with Cisco subject matter expert Aleksandra Dargiel.In particular, Aleksandra will cover...

Hello,I've seen this thread already before and had this already once before with this type of switch. My SG300-20-20 needs a write operation (like copy run start) before it start functioning as it should When connected via the serial I'll see it comp...

I have an SG200 with two vlans. VLAN 1 (default), and VLAN 3. Port 1 of the SG200 is an access port in VLAN 3. Port 24 is a Trunk port with 1UP and 3T. This port is connected to an HP 2920 Layer 3 switch. The port on the HP that is connected to the S...

This is on a Cisco 300 series small business switch, OS version 1.4.0.1 myswitch#sh run interface vlan 1interface vlan 1 ip address 10.62.10.1 255.255.255.0 no ip address dhcp!myswitch#conf tmyswitch(config)#interface vlan 1myswitch(config-if)#ip add...

Hello,I'm searching a switch that does support 10G-Ethernet RJ45 (10GBASE-T) and direct attached SFP+ Twinax (10GBASE-CR).I do not have big requirements, but it should be as cheap as possible.

Hi.I am setting up a configuration using a centralised logging server for about 10 sg300 switches.Switches are all configured using sntp as a time source. Switches show the correct clock time at status page.Timezone is defined with UTC+1, acronym CET...

I have a Cisco SG500-52P switch (2 actually, stacked in Layer 3 mode). I have setup Voice VLAN ID2 for our Mitel phone system. I have all ports untagged on VLAN1 and Tagged on VLAN2.  Our IP Scheme on VLAN1 is 10.0.0.x and on VLAN2 is 172.16.16.x. I ...

Hi all,I have a stack of 9 access switches connecting to distribution switch but now I need to take one out of the stack and connect it directly to distribution switch. Should I be aware of any config change in that access switch beside just unplug t...

Hi, I've enabled 9000 MTU everywhere I could on this switch, but I can't ping greater than 1500.  I imagine that this could be due to a DoS prevention, but there's no setting to turn that off!  What am I missing?Running version 1.0.8.3 Thanks

Does anyone know if this switch is vulnerable to the Shellshock issue? I asked in the Linksys forum, but was told to ask in the Cisco forum. Thanks.

So, I had some trouble yesterday with creating some port-channels and was wondering if anybody has seen this before. I created a port-channel from my 6509 to a 4506 and tried to add two interfaces in an active mode. A couple things happened:    1. Re...