Switches - Small Business

I have just attempted to load the latest firmware on an SLM2008, everything appeared to work as expected BUT, the switch is no longer pingable on its static IP doesn't appear to have attempted get an address via DHCP.  I have attempted power cycling ...

HiWe're currently testing the Cisco SG300-10 for use with multicast TV services/channels but we're having trouble configuring the switch. Our setup is that we have a TV provider which is multicasting all their TV services into the switch's port 3. Th...

Hi,I am battling to configure Line Telnet on a Cisco SG300-10P switch.I am in config mode and enters line telnet,but when I do a show line,telnet still are disabled...what am I doing wrong.Pieter

Hi, I am using SRW2048 switch for our servers . We are not able login in to Switch through WEBGUI, to check any issues, it was working properly ,suddenly, WebGUi is not working. where as we are able to ping and telnet the Switch, and Servers connecte...

I need to confirm how many queues actually supports the switch SG500X?. In SG500X_data_sheet.pdf document (pg. 8) say they have 4 hardware queues (8 future) !. Thanks.

Hi,We've been trying to monitor the used bandwidth of our SGE2000 and SGE2010 switches with Nagios.We've been experimenting with the various OIDs and we've found the OIDs linked to the different switchports.Though when we use SNMPWalk (to find the OI...

We currently have the XG1 through XG4 ports on our SG500X switch setup in a LAG with the Cisco 10G-FiberOptics.  Everything is working fine,however in the web UI under Port Management->Port Settings the "Port Speed" is listed as Unknown.  All other p...

Hi,I'm setting up a Network Monitoring System in Nagios and Nagvis. Now, I want to monitor the cpu and memory of the switches SGE2000 and SGE2010 with SNMP.Does anyone know the OID for the switches SGE2000 and SGE2010 (CPU and Memory).I can't not see...

Hi,I have a weird problem with a Cisco 2901 connected toi a SG300-28 switch.Every 24 hours the router loses connection with the switch, meaning you can not ping the router anymore.You can ping any other device in the network (PC's, servers, other cis...

The switch which is a Linksys Cisco SRW248G4P 48-port 10/100 + 4-port Gigabit Switch, was configured by a contractor which was long ago run off, and the documentation left behind to log into the switch is incorrect. How can we reset this switch so we...

Hi!Is IEEE 802.1v supported by some Cisco SMB switch ? Which model ?Could someone help, please ?Thanks,Leonardo.

Does anybody in this discussion know if this switch supports any SFP's that use the 1000BASE-BX10-D and 1000BASE-BX10-U specs?  The compatibility chart says nay but it can't hurt to ask.I know it's a longshot.thx,