Switches - Small Business

Hi,I have a customer that has 'lost' their mount kit for the switch.  Is there a way to purchase a spare set?Thanks!Chris

Hi Folks,Before I launch into this can I say that I am very much a novice with regards to Managed Switches and their configuration and I hope someone out there can assist me.I have the following equipment which I have connected to the switch:1 x PLC ...

I'm new to vlans and cisco switches and need a bit of direction. I have a my Wifi clients on vlan1 and would like to split them by SSID to vlans 1 & 2. This I can do in my Ubiquiti Unifi controller. All the wifi traffic comes in through one port on t...

I have some doubts about the SGE2000 not located in DataSheet or internet:What standard Memory Switch?Do you have any expansion slot?Supports Per VLAN Spanning Tree (PVST)?Supports Port Secure?Supports configuration templates in Gigabit Interfaces?Th...

Since upgrading the small business switches from the initial factory shipped image(1.0.0.27) to 1.1.1.8 or 1.1.2.0 we are seeing a failure of our config file being completely loaded.  We have a manangement ip on vlan 99 which fails to take when you l...

Hello all,have anyone knowledge if switch Cisco SPS2024 will support CDP protocol in near future? Currently it is not CDP compilant and if there is any neighboring CDP-capable switch connected to it, this switch just broadcasts CDP frames out all oth...

Here is my network layout:I have a cable modem connecting to a Linksys WRT54GL (DDWRT) router. Port 1 on the WRT54GL is connect to port 01 on the SG300-10 switch. On the SG300-10 I've created two Vlans (Vlan 30 & Vlan 40). I assigned ports 3 & 4 on t...

Correction - This was originally posted for my SG300, but it's actually one of my SGE/2010-----------------------------------------I am experiencing an odd behavior from my SG300.  When pinging an IP that is in another VLAN (which requires L3 routing...

Hello everyone,I have a SG200-26 model but I'm having issues updating the firmware image through GUI and TFTP.  I just recently bought this and used it as a regular switch.  Until I wanted to manage certain ports, I found out the GUI was Linksys bran...

Just out of curiosity:PORT1 has a "Secure MAC Address" added (MAC1) and port security set to lock down on a security violation.PORT2 has no port security.PORT2 is mirrored to PORT10.I plugged device with MAC1 into PORT2 and started capturing the traf...

I configured a new SG-200-08 with a static IP. I tried to save the configuration as the startup configuration. After 10 minutes, I restarted the switch. It didn't boot with the new configuration, and returned to the default .254 and default pw. Now I...

According to the documentation, the Switches SFE2010P and SGE2010P have a maximun total power output of 360W. Using only SPA500 series IP Phones that have 10W maximun input, how many SPA500 IP Phones could be connected safely to this switches? 36 ? o...