Switches - Small Business

Hello everyone, I have two switches, SG300-20 and SRW224G4PAt first I only had the SRW switch and had all my workstations and servers connected to it.  I installed the new SG300-20 a few weeks ago.I have all my servers connected to the SG300-20 gigab...

Hi,I have several SG300-10 and SF302-08P switches running with L2-mode, and after I upgraded their firmware to 1.1.2.0, they began to record the following logs every one hour.- Severity: Warning- Description: %COPY-W-TRAP: The mirror-config file is i...

Hi,I've two SG 200-50 and I need to use LACP? What should I do? Adrian

Hi guys,We have roughly 14 ESW-520 switches through out our network which connect wireless APs. We also have 3 VLAN (VLAN1 data; VLAN4 wireless; VLAN100 voice). The access points need to be getting an IP address from the DHCP server on VLAN4 but they...

Hello,So the good people I work for are expanding the office by adding another floor. I thought this would be a good time to segment. Our current network is flat,  VOIP phones and all servers/PC's on the same192.168.1.0 network.  Currently, there are...

Love the 300 series but surprised that Cisco did not put out a 48 port model with gigabit and PoE.  Would love to hear from Cisco on the reasoning behind that and if there are any plans to introduce one?  Given that gigabit and VoIP is the future at ...

Hello!I have two SG300 serie switches and two Gigabit connection between them. How do I configured these two links to work toghether like a one 2 Gigabit channel?thanks a lot.

HiI have been looking into the 300 series switches. I'm a software developer but haven't much experience withh switches and network security, so I need some advice if this is the correct switch for me or if I should look into other swithces. I'm look...

We have a standalone Cisco SGE 2000.We lost connectivity to the web user interface - it no longer responds on the configured IP address.From the manual we see that by default the switch get its IP address via DHCP - but we find no record of any ip ad...

Hi,I have a customer that has 'lost' their mount kit for the switch.  Is there a way to purchase a spare set?Thanks!Chris

Hi Folks,Before I launch into this can I say that I am very much a novice with regards to Managed Switches and their configuration and I hope someone out there can assist me.I have the following equipment which I have connected to the switch:1 x PLC ...

I'm new to vlans and cisco switches and need a bit of direction. I have a my Wifi clients on vlan1 and would like to split them by SSID to vlans 1 & 2. This I can do in my Ubiquiti Unifi controller. All the wifi traffic comes in through one port on t...

I have some doubts about the SGE2000 not located in DataSheet or internet:What standard Memory Switch?Do you have any expansion slot?Supports Per VLAN Spanning Tree (PVST)?Supports Port Secure?Supports configuration templates in Gigabit Interfaces?Th...