Switches - Small Business

A client of us is having a very strange issue. They see a very load (initially just by watching the LEDs en got a software analyzer run on it. Now a software analyzer on a single port, even in promiscuous mode should only get its local data on a sing...

I am unable to configure IPv6 on my SGE2000P. The switch has a link local address:console# show ipv6 interfaceInterface    IP addresses                           Type-----------  -------------------------------------  ------------VLAN 10      fe80::c...

Any hopes of being able to do Pings and Traceroutes from the GUI? It's a little frustrating having to telnet/ssh to do those basic things.It would also be nice to be able to switch to Layer3 mode through the web GUI.

The SGE2000 uses VLAN1 for SNMP Management traffic by default.  I tried to change to VLAN 2 by setting up an Access profile that set SNMP to VLAN 2 but it did not work.  I am using the latest firmware.

Dear,I was trying to activate DHCP Option 82 in the SF300 switch, running in Layer-2 mode.In the DHCP Relay Properties, I enabled the DHCP Relay. I also added the DHCP server where the DHCP messages should be relayed.I also added the VLAN were the me...

I have a SGE2010P and I would like to konw how to agreggate an ip address to a port.  Ex...force the IP address 192.168.0.1 use the port g01 only, if another computer using the same IP try use another port the switch must block that.  The intention i...

Hi, I'm hoping to find some help a problem I've inherited to a degree.... Please bare with me on this.Current setup (What I've inherited) is 3x HP2610 switches which have been configured with vlan10 (untagged, data) and vlan20 (tagged, voice) some po...

I just purchased an SF300-24 managed switch and I am running it in layer3 mode. I am testing it out right now and have it connected to two 2950 switches. The SF300 is connected to each 2950 with a four port etherchannel running LACP. When looking at ...

For quite some time I haven't been able to access the web-ui for my SRW224G4P switch.  The other day I had to shut everything down and when I brought everything back up the switch powered up and you can see the network activity lights on the front.  ...

How to connect two 2960 switch in different location through FO cable with converter.We used FO converter to rj45 between the switches and connect the rj45 port in each switches but the link fail from time to time and the port disabled.Any solution f...

Good afternoon colleagues.There is such a device Linksys SPS224G4.The task for port e1 weighs a computer with the mac-address 00:00:00:00:00:00,and if this port to connect a computer with a mac-address 00:00:00:00:00:01 thenthe port will go into shut...