Switches - Small Business

I'm trying to set up port descriptions on a 5 switch stack of 48 port SGE2010P switches.  Doing this through the Web GUI isexcruciatingly slow.  I tried doing it at the CLI with the 'desc' command, and that seems to work (if I do a show run the descr...

Hello, I recently bought a Cisco Switch SF 100-24, from where the Internet signal is spread to the whole house.That is, the Internet signal comes from the "street" via a cable/modem (from the cable company), andthe Cisco Switch is connected to this c...

Hi all,after having examined all the BPDUs transferred between the various switches by means of tcpdump and wireshark, I think I found the bug here which is really serious: a non-root SLM2008 sends BPDU frames where it steals the root's bridge ID and...

Please advise on how I should setup the fibre ports ( one for receiving vlans and the other for forwarding to a c2960).

I'm throwing this out in hopes of finding a solution.  I just purchased the Cisco SG300-28 to replace an old Catalyst 3548 switch.  I have three VLAN's and I use a separate routing appliance.  My VLANS I use are 1 (management/Trunk), 100 (Regular Acc...

A client of us is having a very strange issue. They see a very load (initially just by watching the LEDs en got a software analyzer run on it. Now a software analyzer on a single port, even in promiscuous mode should only get its local data on a sing...

I am unable to configure IPv6 on my SGE2000P. The switch has a link local address:console# show ipv6 interfaceInterface    IP addresses                           Type-----------  -------------------------------------  ------------VLAN 10      fe80::c...

Any hopes of being able to do Pings and Traceroutes from the GUI? It's a little frustrating having to telnet/ssh to do those basic things.It would also be nice to be able to switch to Layer3 mode through the web GUI.

The SGE2000 uses VLAN1 for SNMP Management traffic by default.  I tried to change to VLAN 2 by setting up an Access profile that set SNMP to VLAN 2 but it did not work.  I am using the latest firmware.

Dear,I was trying to activate DHCP Option 82 in the SF300 switch, running in Layer-2 mode.In the DHCP Relay Properties, I enabled the DHCP Relay. I also added the DHCP server where the DHCP messages should be relayed.I also added the VLAN were the me...

I have a SGE2010P and I would like to konw how to agreggate an ip address to a port.  Ex...force the IP address 192.168.0.1 use the port g01 only, if another computer using the same IP try use another port the switch must block that.  The intention i...

Hi, I'm hoping to find some help a problem I've inherited to a degree.... Please bare with me on this.Current setup (What I've inherited) is 3x HP2610 switches which have been configured with vlan10 (untagged, data) and vlan20 (tagged, voice) some po...