Switches - Small Business

I have two SRW2048 switches.  One was running 1.0.0.50 firmware, and the other 1.2.1 out of the box.  We started having problems with the first switch where a printer would get disconnected from PCs trying to print to it on the same switch.  If I mov...

Hi guys ,i've a problem with tagged vlan with my SRW224G4P.I,ve got following scenario:one cisco 2801-CCME/k9 routerone cisco small business SRW224G4P layer 2 managed switchten cisco IP phone 7940 and 7931ten personal computerI need to use the embedd...

Hi all !Do you know if the SSHv2 access protocol is supported on SRW224G4 switches ?Τhe datasheet and the admin guide refer only the SSH.Thanks in advance.

I can't for the life of me get this figured out.  I would like to setup a PC VLAN (10), a SIP VLAN (20), a SERVER VLAN (30), in addition to the default VLAN 1 that's built into the switch.  I've read every article on here I can find and can not get a...

Hi all,I have just purchased the Cisco 2010P-G5 Small business switch.Questions:Ø  Does this switch support / work with the Cisco call manager and the Cisco PhonesØ  Can you automatically backup the config e.eg daily.Many Thanks

I purchased 2 2960 (2960-24pc-s) switches based on the product literature here... and have discovered that the literature is either misrepresenting the product or my comprehension is lacking somewhat.This document documents the features of the 2960 s...

Hi,I need to block some tcp ports for certain switch ports (block one network access by those ports). But when ever I need I should be able to disable the rule and enable access and again enable the rule (to block the port again).At the moment I have...

Hi,I have an ESW 520 switch, and one of the reasons I bought this switch is so that I could have some piece of mind about what computers are plugged into the wired network.I was hoping to be able to manage this on the ESW 520, however configuring the...

I have recently had access to an SGE2010P and can not find a CLI for it. I have searched on the Internet for instructions on how to get there but they just say to select edit in the login screen but there is no edit when I go to the login screen. Can...

I have a Linksys SRW2024 Gigabit switch with Webview. I need to configure two VLANs on it with one port having access to both VLANs. For example, the default VLAN will have all ports except port 3 and the second VLAN with ports 3, 4, 5 & 6. Could you...

Hi, all my SRW224G4 switches stop sending snmp traps afer some time. When this problem appears all SNMP information becomes inaccessible from web view (communities lits appears empty, views screen starts looping). The only way to sove this is rebooti...

I currently have (2) EF3124 uplinked via fiber. Should there be any issues with compatibility if I install a SRW248G4 switch to replace one of the EF3124 switches over fiber? I realize that the SRW248G4 needs its own fiber module but should there be ...

I am trying to deploy backup solutions for all of our switches and servers and need to know what the power consumption and requirements are for WAT and Volt/Amps. Can anyone tell me what these would be?Thank you,