Switches - Small Business

I'm unable to correctly set the time on a h/w version 3, firmware version 1.01 SLM2024 switch. After attempting to do so, the unit is set to an arbitrary date/time such as 01-02-00 @ 11:19:19 (the current date/time on my unit). Attempts to correct th...

Hello, we have 3 SRW224G4P, we configure them and they work fine. As soon as there is a power failure they all loose some settings and retain others. I'm lost.Information lost includes IP address, VLANS, and VLAN settings for ports however if a port ...

In my offiec i want to connect 8 accesspoints and 8 smart boad and 8 pcs to a switch the access points are cisco 1240g series and controlled by a wlan controller.this switch should be connected to a core switch 4507 using fiber.can i use these esw sw...

We have recently switched to Linksys (now Cisco) managed switches.  The problem is this: I can only seem to get to the switches (via Webview) if I am on a pc that is on the same switch or hub that the managed switch is on!  So, I have gone into the w...

How can we activate the fiber connectivity? by default this is not activated...

I have a SRW224G4. I can create multiple VLAN's but when I try to create another vlan interface and add an ip address to it, I get the error message "ip address table overflow". Is this switch limited to having only 1 IP address? I would like to have...

hi,I have several SRW244 switches. It has been a while and I cannot find all of the ip adresses.Is there a way to scan the netwerk and find the switch to change the ip adress?I've tried the  Cisco network Assistant, but no luck there...

Hello,I'm looking to purchase a Cisco SGE2010P 48-port Gigabit Switch (POE) for a 100% Macintosh environment. Because of this, none of the machines will be able to access the switch (including initial, out of the box setup) via the console port. So, ...

Hi All,Have a question, we have installed 2 SFE2010 via Fiber, i notice that there is no link acttivity on the switch, I have tested the fiber with Dlink Media Convertor and it works. I really need help on this. What do i do ? i have tested with 1 si...

VLANG'day All,We have a central site, with 6 regional sites.Each regional site is connected to the same ISP, and the traffic is divided by them using a distinct VLAN for each site and at each regional site is a simple router that handles DHCP etc.Nor...

I have just bought 4 SGE switches. SGE2000, SGE2000P, SGE2010 and SGE2010P. I’m trying to connect them in a stack but it does not work. It is possible to connect SGE2010 and SGE2010P in a stack but the other models (SGE2000, SGE2000P) will not connec...

Hi,Does the new ESW switches support "Cisco Inline Power" Some Service Providers are using CP-7940/60 with SIP image as a service and need switches that automatically detects that the device only support Inline Power..regards/Bjorn

I have a new SRW2016 switch.  I successfully configured a new administration VLAN, and can connect to the switch via HTTPS.  I configuredthe settings for our RADIUS authentication server (a Windows 2003 Enterprise server running IAS) on the switch.  ...