cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7241
Views
0
Helpful
4
Replies

Cisco SG300 - 28P - Port Security Question.

Parth Maniar
Level 1
Level 1

Greeting's, I would like to enable port security on a Cisco SG300 28P PoE Switch. I would like to know how this can be done in cases where port's are further connected to 8-port desktop switches and in cases where computers are directly connected to the switch.

Thanking you in anticipation,

Parth.

2 Accepted Solutions

Accepted Solutions

Tilman Schmidt
Level 1
Level 1

This is described in detail in section "Configuring Port Security" on pages 326 to 329 of the Cisco Small Business 300 Series Managed Switch Administration Guide document.

The difference between a port serving a desktop switch and one directly serving an endpoint is just the number of MAC addresses you'll want to allow.

Do you have any specific questions?

View solution in original post

Here's 2 documents how to configure port security for dynamic and static.

https://supportforums.cisco.com/docs/DOC-27753

https://supportforums.cisco.com/docs/DOC-27720

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

4 Replies 4

Tilman Schmidt
Level 1
Level 1

This is described in detail in section "Configuring Port Security" on pages 326 to 329 of the Cisco Small Business 300 Series Managed Switch Administration Guide document.

The difference between a port serving a desktop switch and one directly serving an endpoint is just the number of MAC addresses you'll want to allow.

Do you have any specific questions?

Here's 2 documents how to configure port security for dynamic and static.

https://supportforums.cisco.com/docs/DOC-27753

https://supportforums.cisco.com/docs/DOC-27720

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Parth Maniar
Level 1
Level 1

Thank you to both of you. I'm sorry for the spoon feeding i required. I'm sorry and shameful that I did not consult the guide first

Well i small exp. sharing here ..

i would not put a broadcast  control cap on the very port where the 8 port switch is inteneded to be connected .

and ya never be sorry for learning ,its a life process

cheers!!!