09-30-2014 09:43 AM
Hi,
I have a customer who has an 802.3 af-compliant PoE Access Point made by IP Access which powers up correctly when connected to a PoE injector, Netgear desktop PoE switch, and their old SF300 PoE switch, however when we connect to the new SG300-52P it will not boot.
I have disabled all green ethernet settings, but it satill won't boot. When I run the command stating show power inline I can see 30w per port is allowed however I can see a fault on the port. I know the access point and cable are working as I've used them to connect to the other devices, is there a setting I'm missing on the switch to allow PoE to be allocated?
Cheers
09-30-2014 09:52 AM
Hello,
What is the brand of your Access Point?
Regards,
Chris
09-30-2014 09:56 AM
Hi,
It's a ip.access' nanoBTS GSM Picocell.
Cheers
10-02-2014 07:20 AM
Hello,
What is the version of the SF300 and the SG300? Are they both running the same load?
Regards,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide