CSB250-16p-2g vlan setup

[dewin]

Hi everyone,

I just purchased a CSB250 MultiLayer Switch, out of the box in VLAN 1 internet routes through all the ports. I would like my AP's in a separate VLAN and route the internet on both vlans. I setup my Switch (see attached file) through the CLI first with only access ports and then i tried it with a Layer 3 port but no internet. I get my internet through a ISP kabel router modem. ip adres 192.168.1.1 which i connect to port 16 on the switch. I can ping the vlan ip addresss and router port but if i connect my laptop to the switch i don't get internet. is give my laptop a static ip address.

Please help!

Kind Regards.

[balaji.bandi]

if the switch acting as Layer 2, then you can use "ip default-gateway 192.168.1.1"

if you like switch to be part of routing, then ip route 0.0.0.0 0.0.0.0 192.168.1.1 will be good choice.

conf t
int ge 16
no switchport mode
ip address 192.168.1.254 255.255.255.0
no shut

ip route 0.0.0.0 0.0.0.0 192.168.1.1   ( i was hoping 192.168.1.1 is your cable modem IP address ?)

when you do the above config, from switch are you able to reach or ping 8.8.8.8 or 1.1.1.1 ?

if that is working, since your other subnet not part of network address translation, so those will not able to reach internet.

192.168.10.0/24

is the cable modem youcan make any changes?

like add 192.168.10.0/24 for network address translation

add statc route back 192.168.10.0/24 network towards switch IP that is 192.168.1.254 ?

[dewin · Accepted solution]

Thanks balaji.bandi for your reply!

is the cable modem youcan make any changes?

No, the cable modem is the problem (almost nothing to change) 

Thanks to your input i setup my switch and i am going to set my cable modem in Bridge mode and

create a pfsense router.

Kind Regards.

[balaji.bandi]

sure and glad you found the alternative solution here.