cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
690
Views
0
Helpful
1
Replies

Firmware Best practices

ihmtech01
Beginner
Beginner

Any suggestions on best practices for firmware upgrading. Currently using a combination of SF200 switches (SF200-48, SF200-24, SF200-24P, SF200-24FP), WAP561, and WAP321. The question is should I step the updates from the current to the most recent or can I just update to newest release?

1 Reply 1

Aleksandra Dargiel
Cisco Employee
Cisco Employee

Hello,

For the switches please bear in mind the following upgrade steps:

https://supportforums.cisco.com/document/12321266/firmware-upgrade-troubleshooting-300-and-500-series-managed-switches

 

Please note that with boot code 1.3.5.06 there are quite important change in file system so before proceeding to 1.4.0.88 you will have to upgrade switch to 1.3.7 firmware not boot code 1.3.5.06.

For the access points it is not the same case however please always check release notes of the latest firmware for special instructions.

Regards,

Aleksandra

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X