i need supports for cisco switch SLM224P

[cindy toy]

(This question was originally posted as a document and was copied over here.  The original question is located here: https://supportforums.cisco.com/docs/DOC-23120)

dear Eng

i need supports for how can config SLM224P with UC540    

regards

[Tom Watts]

Hi Abdulelah, the older SLM switch will need all manual configuration. If you're using the typical vlan 1, vlan 100 then the expected configuration of the switch would consist of the following-

• The link between the switch and UC configured as 1untagged, 100tagged
• The link between the telephone and the switch configured as 1untagged, 100tagged
• The links connecting the phones should have spanning-tree portfast enabled

Please keep in mind the old SLM switches do not support auto voice vlan, LLDP, CDP, etc. A SX200, SX300 or SX500 switch would be a more appropriate device for a UC deployment as the SX200 and SX300 are supported by CCA and is basically a zero config deployment as far as the switch is concerned.

-Tom
Please mark answered for helpful posts