10-16-2015 03:00 PM
I am unable to upgrade the firmware on a SG200-08 switch. After starting the upload via HTTP is runs for a long time and then fails with the error "transfer aborted". Can't seem to get an upgrade to to ever work. I'm attempting to upgrade from 1.0.6.2 to 1.0.7.4.
10-23-2015 04:03 AM
hi Wesley
07-07-2016 11:46 AM
I have this very same issue, upgrading from 1.0.6.2 to 1.0.8.3.
Have tried with IE and Chrome.
IE Fails with the above error.
Chrome doesn't even start. When I hit upload I got an empty pop-up box with only an OK button..
09-05-2016 03:05 AM
finally....SUCCESS
MSIE 11 failed, as did Chrome, but finally tried Mozilla Firefox and got the progress bar. Be patient and let it run. I did leap from ....6.. directly to 1.0.8.3.
05-04-2018 06:27 PM
I have tried MS Edge, Chrome and FireFox without success. Followed the procedure, but after clicking on the Apply button it just comes back with the OK button and cannot upgrade the firmware from version 1.0.6.2 to 1.0.8.3 using the downloaded file SG200-08x_FW_1.0.8.3.stk file. Is there an absolute successful install upgrade procedure out there?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide