SG200-50 firmware not available for download

[abimaelrios2002]

Hi, I need archived firmware sx200_fw-1_3_7_18.ros for SG200-50 (EoL). Serial is out of support but I only need the intermediate file to upgrade. Portal rejects the case.

[Mark Elsen]

 - @abimaelrios2002         Cisco no longer offers software downloads for products that are past support

  M/

[Enes Simnica]

gDay @abimaelrios2002 checked my local archive and found several firmware files that might help. Specifically I have;;

• SX220-R1.2.1.5
• image_tesla250_hybrid_2.5.9.54_release_cisco_signed
• sx200_fw_1.3.7.18.ros
• Plus a few additional files for the SF200 and SF220 series

I'll paste the full list below, and maybe maybe will help

hope it helps!

-Enes

[Enes Simnica]

also @abimaelrios2002 these: 

[abimaelrios2002]

Hi @Enes Simnica 

Thanks a lot for sharing the files! However, it looks like the sx200_fw_1.3.7.18.ros - Shortcut.zip is actually a shortcut link pointing to a file on the drive, not the actual archive. Could you please upload the full zip file instead?

Thanks again for the help!

[Enes Simnica]

hello @abimaelrios2002 check this one. And if doesnt work, I'll check again tomorrow morning my G. 

For now, IM OUT!

[abimaelrios2002]

Hey @Enes Simnica 

Thanks for the file! The SF200-24.zip you shared actually contains the sx200_fw-14115.ros firmware, which is the latest version.

However, I’m specifically looking for the sx200_fw_1.3.7.18.ros file — I need that older version for compatibility testing.

Really appreciate your help!

[SirFrimFram]

Hello @Enes Simnica do you by chance have firmware and boot code files for the SG300 series? In particular the in between versions needed in order to upgrade to the latest versions (Boot code 1.3.5.06 and Firmware 1.4.11.5 --- correct me if those are not the most recent releases).

[graden]

I have v1.4.7.2

[peoyli]

@Enes Simnica do you have the last version of the bootcode for SG200 as well, or is it not needed when updating from 1.3.7.18 to (I have bootcode 1.1.0.6 in at least the switch I successfully updated to firmware 1.3.7.18) to firmware 1.4.11.5 (last ever version) ?

[Zulfan Zulkifli]

Hi Sir,
I have the firmware and boot code for the SG200 switch. The Sx200_FW_Boot_1.4.1.03 file contains boot code version 1.3.5.06, which is required to upgrade to a newer firmware.

[peoyli]

Hi, and thanks for the bit late response. I've found the needed files a while ago and successfully updated my SG200s at that time.

Hopefully this will help other homelab users (or for training purposes, because old hardware still exists at some places) to update their switches. Still.. Too bad Cisco does not provide a file archive for their ancient hardware ("no support", but let at least people get the files an get help from a community that would be much stronger if this happened).

I also downloaded the files you supplied to compare the checksum with those I have (but they will probably match - I have so far not found any different/manipulated/corrupt files of the same versions).

[SirFrimFram]

Thank you Zulfan! 

I was able to get the files from a reddit user, but thank you for sharing! I'll post that link as well.
https://archive.org/details/cisco-sx300-series-switch-firmware