SG220-26P

[gianmaria.iaculo]

Hello,

we just received a SG220-26P Poe Switch. We are tring to power on a passive poe device ( Ubiquiti Rocket Prism GEn2 - https://www.ubnt.com/downloads/datasheets/RocketAC/Rocket_Prism_AC_Gen2_DS.pdf). I think this is no autosensing, no 802.x standard. How can I enable PoE manually. This device need 9500 mw max power. Is it possible?

Regards,

Gianmaria 

[Deepak Kumar]

Hi,

Passive PoE does no such negotiation, and as such is always sending electric current out over the ethernet cable at a certain voltage regardless of the device it’s going to.

You can try with legacy POE mode or manual set required power

See the guide (page 360) :

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbss/sf220_sg220/command_line_reference/Sx220_CLI_Guide.pdf

Regards,

Deepak Kumar

[gianmaria.iaculo]

Thank you so much Deepak,
I'm new to Cisco CLI. I tried to find right commands to enable manual PoE but without success.

Actually in CLI i do:

- config
- interface GigabitEthernet 12
- power inline limit 9000

But the Device were not powered. Sure I'm missing something. Can you give me the right sequance to gi e power to this Port? This a 24V Device.


Regards,
Gianmaria