Solved: SG250X secure web interface not reachable

gioscud · ‎09-24-2021

Hello,

I have a couple of SG250X -24 port wit firmware 2.5.7.85, after a while the web interface is not more reachable through https protocol, I need to enable the http server via cli.

I upgraded the firmware from 2.4.0.94 version to try to resolve this problem, did any else resolve the same problem?

Thank you

BR

Giovanni

Martin Aleksandrov · ‎09-29-2021

Hi,

If you configure through cli then make sure you enable the secure web server by issuing ip http secure-server. When this command is used you must generate certificate using crypto certificate generate, otherwise this command has no effect. See “Web Server Commands”, chapter 57 of the CLI guide: https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbms/250_/2_4_5/cli_guide/cli_sx250_2_4_5.pdf

And don’t forget to save the config.

Thanks

View solution in original post