キャンセル
次の結果を表示 
次の代わりに検索 
もしかして: 
cancel
665
閲覧回数
0
いいね!
0
返信

SG350XG-48T Optical Module not coming up. Disable copper on the combo port?

BVR EDV
Level 1
Level 1

Hi,

can we set the switch to use only the fiber media on Port 24/48?

Is it possible to disable the copper port on the combo Port?

We have the problem that the optical module switches off as soon as an optical signal is lost.
Sometimes it takes hours for the fiber optic media to be available again.

 

the log shows only following:

Informational %LINK-I-Up: Vlan 30
Informational %LINK-I-Up: te1/0/48
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from fiber media to copper media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from fiber media to copper media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from fiber media to copper media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from fiber media to copper media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from copper media to fiber media on port te1/0/48.
Informational %LINK-I-CHNGCOMBOMEDIA: Media changed from fiber media to copper media on port te1/0/48.

Do we have to use an other Switch

0件の返信0