Showing results for 
Search instead for 
Did you mean: 

SGE2010 compatibility with windows 7 pro 64 bit?

Level 1
Level 1

Is there any issues with accessing the browser based GUI using Windows 7  64bit on a SGE2010 switch? I took the switch home and tried on my XP 32bit machine and works fine, but no luck on any windows 7 64bit pc's. I have tried 3 different new pc's on this new switch and no luck at all. Any suggestions?

2 Replies 2

Level 1
Level 1

Perhaps the manual should mention to set your IPv4 to

subnet to

Default Gateway to

After doing this, I can finally access the GUI.

I am disappointed in Cisco's documentation for this.

I hope the rest of my setup isn't so difficult.

also, No replies to my plea for help is also disappointing, Especially for the price I paid for all the Cisco hardware I purchased.

Hello Tom,

I am sorry we were not able to assist you with this before you found the solution. For more immidate assist I recommend calling us here at the SBSC. Below is a link which has the phone numbers you can use to reach us.