cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1068
Views
0
Helpful
2
Replies

SLM224G Firmware after-upgrade UI error

stormforce133
Level 1
Level 1

Hi! I've recently upgraded the firmware, from 1.0.1 (factory firmware) to 2.0.0.10.

When I open the Port Configuration section or any other that shows port list I get this:
slm224g error.PNG

And I get half of the port's list.

Any ideas?

Thanks!

PD: The web UI only works on Firefox.

2 Replies 2

Tom Watts
VIP Alumni
VIP Alumni

Hi Exequiel, I'd recommend using a different computer to see if it's any different.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Hi,

I need firmware 2.0.0.10.

Can you make the firmware available?

 

Regards,