cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1486
Views
5
Helpful
2
Replies

SVI support on SG 300 series switches

khurram1987
Level 1
Level 1

hi people:

my client have 6 sg 300 switches one switch is connected with firewall an d firewall has dhcp server of one network, they want to make another vlan of another network, if sg 300 series support SVI's than i can make two svi's on my one switch.i think they dont support svi other than default.can you help me out on this problem...

1 Accepted Solution

Accepted Solutions

Tom Watts
VIP Alumni
VIP Alumni

Hi Khurram, the switch does support layer 3 vlan interfaces.

You may log in to the CLI and use the command

set system mode router

Once you do this, this will factory default reset the switch after reload.

Once the switch has come back up, ensure the first thing you do is make a static IP address on vlan 1 then proceed to make your additional vlans and ip addresses on the vlans

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

2 Replies 2

Tom Watts
VIP Alumni
VIP Alumni

Hi Khurram, the switch does support layer 3 vlan interfaces.

You may log in to the CLI and use the command

set system mode router

Once you do this, this will factory default reset the switch after reload.

Once the switch has come back up, ensure the first thing you do is make a static IP address on vlan 1 then proceed to make your additional vlans and ip addresses on the vlans

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Thanks Tom for your valuable words, it has helped me alot and problem solved once i did it to router mode.

thanks