07-25-2007 05:10 AM - edited 03-05-2019 05:28 PM
Hi,
I have a 1721 with a 10 baseT wic configured with duplex full paramenter.
When I plug the rj45 wire into the switch, the fdx led does not enable.
Why?
Solved! Go to Solution.
07-25-2007 06:09 AM
10BASE-T is not a full duplex specification.
On some equipment you can set 10 Megabit, full duplex and it'll work.
On some equipment you can set 10 Megabit, full duplex, and it'll reject the parameters (with an error message)
On some equipment you can set 10Megabit, full duplex, and it'll look like it accepted the setting, but it won't work.
In any case, if you set 10 megabit, full duplex, it is not 10BASE-T; 10BASe-T does not include full duplex as part of its specification.
Good Luck
Scott
07-25-2007 06:09 AM
10BASE-T is not a full duplex specification.
On some equipment you can set 10 Megabit, full duplex and it'll work.
On some equipment you can set 10 Megabit, full duplex, and it'll reject the parameters (with an error message)
On some equipment you can set 10Megabit, full duplex, and it'll look like it accepted the setting, but it won't work.
In any case, if you set 10 megabit, full duplex, it is not 10BASE-T; 10BASe-T does not include full duplex as part of its specification.
Good Luck
Scott
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide