2511 reverse telnet

[cisco steps]

Hi again . now I was able to get from comm-server 2511 to 2610 when I canfigured the loopback0.. now I wan to getback to 2511 com-serv its says on the doc that I need to do Ctrl+shift 6, twice// I did but I am still on the R1 PROMT

do I need to config a loopback0 on 2610 so it will go back to 2511.. ?

Thanks

[CSCO10892433 · Accepted solution]

Type "Ctrl+shif-6" then "X"

HTH

SSLIN

[cisco steps]

you mean hit the key Ctrl+shif-6 the letter X or type it ..

[CSCO10892433 · Accepted solution]

Please follow these steps

1. Press the keys "Ctrl","shift","6" at the same time.

2. Release the above keys.

3. Hit the key "x"

Hope this works. If not, let me know.

SSLIN

[cisco steps]

thanks will try and let you know, not near the lab today/

[cisco steps]

I was able to got from 2511 to R1.. I did what its says .. but i does not work.

R1#x

% Ambiguous command: "x"

R1#xR1#x

R1#show session

% No connections open

R1#show sessions

% No connections open

[cisco steps]

I was able to firuge it out.. I guess I ahve to be on enable user mode.. then apply the command ..

Thanks for the help

R1#disable

R1>

2511sw#

[CSCO10892433]

Hi, ocporbust

That sounds strange. I had used this command for thousands times. It worked no matter the router was on user mode or exec mode.

Would you please try it again?

Regards

SSLIN

[cisco steps]

sorry for the delay of my response, I did it this time and it did work from the ex mode.. Thanks