02-25-2010 01:46 AM - edited 03-06-2019 09:53 AM
Hi Everyone, I've a 2950G that from time to time logs the Internal POWER supply is FAULTY message. The switch is operating normally, it's not rebooting and isn't connected to an RPS. The IOS version is .121-22.EA8a. Has anyone any idea whether this is a genuine hardware problem or is it software related?
best wishes, Mike
Solved! Go to Solution.
02-25-2010 02:51 AM
Hi Mike,
If 'show env all" does not presents any PS failures, then it could be some cosmetic issue.
For example, could be due to the not fully correct changes in the code
done under CSCsb73608 "2950 does not generate error message when power supply fails",
which in turn were corrected in 12.1(22)EA9 under CSCse84332.
Thanks,
Sergey
02-25-2010 02:51 AM
Hi Mike,
If 'show env all" does not presents any PS failures, then it could be some cosmetic issue.
For example, could be due to the not fully correct changes in the code
done under CSCsb73608 "2950 does not generate error message when power supply fails",
which in turn were corrected in 12.1(22)EA9 under CSCse84332.
Thanks,
Sergey
02-25-2010 02:58 AM
Thanks for your answer Sergey, I'll try the code upgrade
best wishes, Mike
06-09-2010 08:27 AM
Hi,
have you news about this problem ?
I have the same error after upgrade.....last IOS 12.1(22)EA13
thank's for a feedback
regards
06-09-2010 11:58 PM
Hi, the code upgrade didn't fix the problem, the switch has continued to work but the CLI showed psu fault. We plan to replace the switch just in case the psu suddenly dies, best wishes, Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide