Hi, after OIR of GLC-SX-MM into Cisco 2960-24TC-L I am getting this log:
Jul 16 14:47:03: %SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (1/1),process = hpm main process.
Jul 16 14:47:06: %SYS-3-CPUHOG: Task is running for (4194)msecs, more than (2000)msecs (1/1),process = hpm main process.
Jul 16 14:47:08: %SYS-3-CPUHOG: Task is running for (6292)msecs, more than (2000)msecs (1/1),process = hpm main process.
Jul 19 09:18:38: %SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (0/0),process = Virtual Exec.
Jul 19 09:18:42: %SYS-3-CPUHOG: Task is running for (2098)msecs, more than (2000)msecs (0/0),process = hpm main process.
Jul 19 09:18:44: %SYS-3-CPUHOG: Task is running for (4195)msecs, more than (2000)msecs (1/0),process = hpm main process.
Jul 19 09:18:47: %SYS-3-CPUHOG: Task is running for (6292)msecs, more than (2000)msecs (1/0),process = hpm main process.
Interface Gi0/1 doesn't recognize SFP modul. Interface Gi0/2 recognize it but it won't come up.
sh int g0/1
GigabitEthernet0/1 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet, address is 001b.0d80.5f19 (bia 001b.0d80.5f19)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Auto-duplex, Auto-speed, link type is force-up, media type is unknown
input flow-control is off, output flow-control is unsupported
#sh run int g0/1
!
interface GigabitEthernet0/1
switchport trunk allowed vlan 10,40,45,50,55,100
switchport mode trunk
switchport nonegotiate
media-type sfp
speed nonegotiate
end
Version of IOS is:
System image file is "flash:c2960-lanbase-mz.122-25.SEE3/c2960-lanbase-mz.122-25.SEE3.bin"
What could be an issue here? Thanks.
