2960-X - Boot Fail after Firmware upgrade

[kalweit01]

Hello,

I was upgrading the firmware of one of our 2960-X Switches to c2960x-universalk9-tar.152-2.E3. When the firmware was updated the switch rebooted and was coming up with "BOOT FAIL".

I am not able to get to ROMmon. It has no reaction if I press the Mode button at start or trying to send a break in Terminal, also a CTRL+C, CTRL+Break or any other key combinations are not helping.

Any suggestions?

[Mark Malone]

I would repost that in this link below as there's a cisco 2960x expert answering questions until Friday on these platforms, you should also provide the terminal output as it boots up an the steps you took to deploy it , the more information the quicker you will get a solution

https://supportforums.cisco.com/discussion/12982571/ask-expert-catalyst-2960-x-and-2960-xr-switches-overview-configuration-and

[kalweit01]

Posted it there too. Thx for the hint.

[jackson.ku]

Hi,

I have got the same issue. Do you find the method to resolve it?

Best Regards,

Jackson Ku

[mortezasadeghi]

I have got the same issue too.

can anyone help us!!!

[Abrar_Ali]

I am facing the same issue. If you found a resolution, please share as i need it on urgent basis.
abrar.exalted@gmail.com is my e-mail.
Thanks and regards.

[saloaun18]

hi, did u resolve this issue?

[Abrar_Ali]

By changing the device lol