cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8482
Views
5
Helpful
7
Replies

2960G Switch is not able to reload

md farook
Beginner
Beginner

Dear All,

Recently i have observed that one of my network Switch is not able to reload automatically. Whenever i try to fire RELOAD command it showing following error

Switch#reload

%ERROR: Not able to process Signature in flash:.

%ERROR: Aborting reload.

So kindly help me on this

7 REPLIES 7

Lucien Avramov
Advocate
Advocate

Try to disable file verity auto:

Switch(config)#no file verify auto

Its working.

thanks

now it able to reload automatically but once it accept reload command again it move in

Switch: mode and again i need to assign the path of the flash to reload.

What is the switch showing you with:

show boot

Do you have the boot path manually configured in the config file with boot system flash:path_to_image?

You can also verify what's in flash with:

show flash

I had same problem on 2960X stack of 2. I confirmed image was good with:

verify /md5 flash2:/IMAGE.bin

config:

no file verify auto 

worked. Image loaded fine on second unit in stack

This worked for me on a 2960x

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

What IOS is this? I've never seen this behaviour before.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: