cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2704
Views
0
Helpful
2
Replies

2960S-48TS-L take 10 minutes to boot and start, why?

Echo Chan
Beginner
Beginner

Dear Expert,

May I know why my 2960S-48TS-L takes 10 minutes to boot and start, some just take 1 minute, but one of them take up to 10 minutes, but after that it works fine, why?

Thanks

2 Replies 2

Arumugam Muthaiah
Cisco Employee
Cisco Employee

Hi Echo,

Do you the console los while the switch bootup time? I am not quite sure why does it taking long time to boot but you could try this below option, then check the performance.

  • Reformat the flash
  • Download the IOS image again (make sure you have enough room avilable to copy image on flash drive)
  • Please ensure that you don't reboot until you verify that there is a good IOS image in flash.
  • Then reload the switch, and check the performance

Regards,

Aru

*** Please rate if the post is useful ***

Regards, Aru *** Please rate if the post useful ***

thanks, let me check, I will come back to you when have the result.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers