Hi, I have an Catalyst 3560 with IP Services IOS and it doesn't allow me to configure 802.1x port-control.
it doesn't accept the commands.
I've already checked in feature navigator and the version i'm using support it, i tried 2 more versions too to be sure it was not a version problem.
Is there samething i'm missing?
nterface FastEthernet0/15
switchport access vlan 10
switchport mode access
!
Switch(config)#int fa 0/15
Switch(config-if)#dot1x ?
credentials Credentials profile configuration
default Configure Dot1x with default values for this port
max-reauth-req Max No.of Reauthentication Attempts
max-req Max No.of Retries
max-start Max No. of EAPOL-Start requests
pae Set 802.1x interface pae type
supplicant Configure supplicant parameters
timeout Various Timeouts
As you can see it doesn't shows me the "dot1x port-control" option
The feature navigator show for my hardware and software version:
IEEE 802.1x - Auth Fail Open IEEE 802.1x - Auth Fail VLAN IEEE 802.1X - Flexible Authentication IEEE 802.1x - VLAN Assignment IEEE 802.1x Authenticator IEEE 802.1x Fallback support IEEE 802.1x Multi-Domain Auth with Voice VLAN Assignment IEEE 802.1X Multi-Domain Authentication IEEE 802.1x RADIUS Accounting IEEE 802.1x Readiness Check IEEE 802.1x Supplicant Support for EAP-FAST IEEE 802.1x Supplicant Support for MD5 IEEE 802.1X Voice Aware Security Violations IEEE 802.1x with Port Security
