12-08-2010 12:10 PM - edited 03-06-2019 02:25 PM
I am testing a record software for Cisco IP Phones. This software must receive voice traffic from mirrorred ports on a 3560 switch. I´ve configured the span ports in this switch, but the only traffic I can see is broadcast and multicast. I didn´t see neither the audio streamming nor the call signaling (I can´t see any unicast traffic). Below is part of the configuration of the 3560 switch.
spanning-tree mode rapid-pvst
spanning-tree loopguard default
spanning-tree portfast bpduguard default
spanning-tree etherchannel guard misconfig
spanning-tree extend system-id
spanning-tree uplinkfast
spanning-tree backbonefast
!
vlan internal allocation policy ascending
!
!
!
interface FastEthernet0/1
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/2
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/3
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/4
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/5
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/6
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/14
switchport access vlan 23
switchport mode access
switchport voice vlan 51
spanning-tree portfast
!
interface FastEthernet0/48
speed 100
duplex full
spanning-tree portfast
!
monitor session 1 source interface Fa0/1 - 6 , Fa0/14
monitor session 1 filter vlan 51
monitor session 1 destination interface Fa0/48
The ports with IP Phones are 1 to 6 and 14. The port that will receive the VoIP traffic is 48.
The switch is loaded with C3560 Software (C3560-IPBASE-M), Version 12.2(50)SE1.
Have anyone had this problem before?
Best Regards.
Fujimura.
12-14-2010 06:21 AM
Hi.
I´ve tried this already, but I did it again. I´ve upgraded too the ios to 12.2(55)SE1-C3560-IPBASEK9-M version.
After the command is done (monitor session 2 dest int fa0/48 enc replicate), I can see no more traffic, neither broadcast, nor multicast.
Best Regards.
Fujimura.
12-14-2010 06:41 AM
Could you check if any traffic is captured(without encapsulation replicate) at the destination port by a PC with wireshark ?
-Reghu.
12-14-2010 08:25 PM
Hi.
I tested with my own notebook. I used wireshark and packetizer sniffers. With no "encapsulate replicate" option (command "monitor session 2 destination interface fa0/48"), i see only broadcast and multicast traffic. I changed the destination port too, but the problem still happens.
Best Regards.
Fujimura.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: