04-18-2013 11:04 PM - edited 03-07-2019 12:55 PM
hello!
I have 3560g with 15.0(2)SE2 version. I try to give different default gateways for different interfaces.
I've already changed the sdm, run "ip routing" and made interest interfaces in "no switchport" with ip addresses.
my route-map is "
route-map ABC permit 10
set ip next-hop 192.168.77.3"
and it is applied on the interface with "ip policy route-map ABC"
but when I try to apply it says "%PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map ABC not supported for Policy-Based Routing"
everything is fine if I change from "set ip default next-hop" to "set ip next-hop"
but it is not I need
in the guide of the version it is said this statement is not in unsupported list of route-map commands.
please help me!
Sergey
Solved! Go to Solution.
04-18-2013 11:53 PM
Hello, please see this article, it may help?
http://www.booches.nl/2008/06/policy-based-routing-catalyst-3560/
Sent from Cisco Technical Support iPhone App
04-18-2013 11:53 PM
Hello, please see this article, it may help?
http://www.booches.nl/2008/06/policy-based-routing-catalyst-3560/
Sent from Cisco Technical Support iPhone App
04-19-2013 01:08 AM
have seen it already.
link from this page is applied to 3550 and older version of firmware.
my link does not show "set ip default next-hop" as unsupported
04-19-2013 01:12 AM
my fault
I see it does not support its command.
does that Catalyst have some version with this command allowed?
04-19-2013 03:16 AM
Hello, having had a look at the cisco feature navigator, it seems that the default next-hop feature in IOS is only available on the ME6524, MWR2941, 6000, 7600, 7301, 7201 and 7200.
hope this helps
Please rate useful posts and remember to mark any solved questions as answered. Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide