cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3342
Views
5
Helpful
2
Replies

3650 password recovery enabled procedures

 

I can't recovery the password, this is my step:

 

switch: flash_init
switch: load_helper

Unknown cmd:
switch: rename flash:config.text flash:config.old

rename: read only file system

 

switch: set

ABNORMAL_RESET_COUNT=0
ASIC_PCI_RESET=1
BOOT=flash:packages.conf
BOOT_LOADER_UPGRADE_DISABLE=1
BSI=0
BYPASS_STARTUP_CONFIG== 1
BYPASS_START_CONFIG== 0
BY_PASS_STARTUP_CONFIG== 1
CFG_MODEL_NUM=WS-C3650-48TD-S
CLEI_CODE_NUMBER=IPMV410BRE
CSR_PCIERST_DISCONNECTED=yes
DC_COPY=yes
D_STACK_DOMAIN_NUM=1
ECI_CODE_NUMBER=469507
MAC_ADDR=70:DF:2F:EF:AD:00
MANUAL_BOOT=no
MODEL_NUM=WS-C3650-48TD
MODEL_REVISION_NUM=P0
MOTHERBOARD_ASSEMBLY_NUM=73-15896-05
MOTHERBOARD_REVISION_NUM=A0
MOTHERBOARD_SERIAL_NUM=FDO21181VNW
RANDOM_NUM=911359988
RECOVERY_BUNDLE=sda9:cat3k_caa-recovery.bin
RET_2_RTS=11:02:51 TH Mon Jan 25 2021
SWITCH_IGNORE_STARTUP_CFG== 1
SWITCH_NUMBER=1
SYSTEM_SERIAL_NUM=FDO2120Q1N6
TAN_NUM=800-41239-03
TAN_REVISION_NUMBER=B0
TEMPLATE=advanced
TERMLINES=0
VERSION_ID=V04

 

How should I do?

 

Thank you very much.

1 Accepted Solution

Accepted Solutions

It worked by:

  1. boot to rommon
  2. switch: set BYPASS_STARTUP_CONFIG== 1
  3. switch: boot
  4. push reset button on sw
  5. unplug power cable an boot to rommon again
  6. switch: set BYPASS_STARTUP_CONFIG== 0
  7. switch: boot

Thank you very much.

View solution in original post

2 Replies 2

It worked by:

  1. boot to rommon
  2. switch: set BYPASS_STARTUP_CONFIG== 1
  3. switch: boot
  4. push reset button on sw
  5. unplug power cable an boot to rommon again
  6. switch: set BYPASS_STARTUP_CONFIG== 0
  7. switch: boot

Thank you very much.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco