02-07-2019 05:08 AM - edited 03-08-2019 05:16 PM
Hi.. got a 3750 Switch.. Followed details for reset via console etc..
then accessed it via web portal on 10.0.0.1 and changed to my Lan range, 192.168.0.199 Gateway ..0.1
and rebooted and can see it and connect to it even through another pc on another switch on the lan. but wont access to wan.
any ideas, must be something simple.
not an expert on this stuff hence struggling..
Thanks in advance..
02-07-2019 05:20 AM
Hi there,
You mention WAN in your post. Does the WAN device have an interface in the 192.168.0.0/24 subnet? The gateway address 192.168.0.199 is that switch or the WAN device? If it is the switch and you are using it for routing, does it have a default route directing traffic to the WAN device.
Please share the output from these commands:
sh ip int br
sh ip route
cheers,
Seb.
02-14-2019 10:08 AM
hi..
Its just on a simple network at home..
got normal router on 192.168.0.1
managed to reset switch to now be on 0.199 (and can access via IE)
But it wont let any traffic through it to the internet .
sh ip int br
says..
Vlan 192.168.0.199 yes. NVRAM up down
all rest say unassigned yes unset down down
sh ip route says
Default gw 192.168.0.1
ICMP redirect cache is empty
if you have 5 mins could you remote and sort for me for a beer?
02-14-2019 12:22 PM
Can you share the entire running config of the switch, and tell us which switchport the ISP router is connected to?
cheers,
Seb.
02-14-2019 03:04 PM
Hi,
Please share the running configuration.
BR
Tayyab
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide