cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

3750 Manual Boot Setting

Ciesm0graph
Beginner
Beginner

RVHManBoot.JPG

I have a customer with a 3750x4 stack. We rebooted the stack over the weekend and the master did not come back up. Upon investigation it was discovered that tghe master was set for Manual Boot. I tried issuing the "no boot manual" command in Global Config mode but it did not change the variable according to a show boot command. According to Cisco documentation, the "no boot manual" command only works on standalone devices.

Does anyone know of a way to change the variable while the switch is a member of a stack?

1 REPLY 1

singhaam007
Participant
Participant

Hello Craig,

Could you please try this.

1.          switch: set BOOT flash:IOS image name that you load to flash.bin

  1. switch: unset MANUAL_BOOT
  2. switch:boot

and then try sh boot.

Please rate if this helps.

thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: