10-07-2020 03:19 AM
Hello.
We have a 3750 and currently using the sdm template "desktop IPv4 and IPv6 default" we use this as we do IPv6, but i am trying to configure netflow but the commands do not seem to be recognised.
Is there any advice on what we need to do to enable netflow commands or what SDM we need for it, this is for a Level 3 Switch.
Kind Regards,
Chris
10-07-2020 03:25 AM
check the below Link and supported verion required. ( you can use one of Cat 3K template should work).
https://community.cisco.com/t5/security-documents/netflow-support-matrix/ta-p/3644638
10-07-2020 03:39 AM
Hello @CobbyJ ,
if you have a Cisc 3750-X netflow support requires appropriate uplink module installed:
see the document provided by BB the rightmost column says:
>> only on SM-10GB Module
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide