3750-X Flexible NetFlow on GigabitEthernet ports

[joan.luque]

Hi all,

I tried to configure Flexible Netflow on Cisco Catalyst 3750-X stack with no lucky. I read the documentation and I assumed that we can configure the Netflow in all ports of the C3KX-NM-10G modules, that's right or only is possible configure Netflow on the TenGigabitEthernet ports?

I have connected my uplinks ports with 1000BaseLX SFPs.

This is my configuration:

flow record TEST
 description Test Exporter
 match datalink mac source-address
 match datalink mac destination-address
 match ipv4 tos
 match ipv4 ttl
 match ipv4 protocol
 match ipv4 source address
 match ipv4 destination address
 match transport source-port
 match transport destination-port
 collect interface input snmp
 collect interface output snmp
 collect counter bytes
 collect counter packets
 collect timestamp sys-uptime first
 collect timestamp sys-uptime last
!
flow exporter TEST
 description Test Exporter
 destination A.B.C.D
 source Vlan500
 transport udp 7021
!
flow monitor TEST
 description Test Monitor
 record TEST
 exporter TEST
 cache timeout active 60
!
interface GigabitEthernet1/1/1
 switchport trunk encapsulation dot1q
 switchport mode trunk
 ip flow monitor TEST input
 ip flow monitor TEST output
!

[joan.luque]

No one could bring some clue about it?

[Joseph W. Doherty · Accepted solution]

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Not 100% sure, but I thought 3750-X FNF depends on having a C3KX-SM-10G installed (not the C3KX-NM-10G).

[joan.luque]

Hi Joseph,

I guess you are right: http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3750-x-series-switches/white_paper_c11-691508.html

I mistook the PN!