05-08-2019 11:09 AM
I have a 48 port 3850 switch that reboots into ROMMON every time the switch is recycled....can you please provide what the confreg settings should be. To get the switch to boot into full operational mode I have to console into the switch and run the Boot command.
Thank You
05-08-2019 11:23 AM - edited 05-08-2019 11:23 AM
Post the complete output to the command "sh boot" & "dir".
05-08-2019 11:26 AM
Hi @johnmike ,
Check what this manual says:
The factory-default setting for the configuration register is 0x2102. This indicates that the router should attempt to load a Cisco IOS® software image from Flash memory and load the startup configuration with a console speed of 9600 baud.
It tells you how to make the register change as well.
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: