I am trying to replace my SupII in a 4006 to a Sup IV that I purchased off ebay. Not having much luck at the moment. I swapped out the supervisors and removed all my line cards. The "new" Sup IV status just fast blinks green, utilization is at 100% and the console port is unresponsive. I have tried to reseat the supervisor and reset.
1. Log into CLI of DNAC:
ssh maglev@< DNAC appliance IP> -p 2222
2. Run this curl command to get token to get member id:
curl -X POST -u admin:<admin user password> -H -V https://<CLUSTER-IP>/api/system/v1/identitymgmt/token
Enterprise Switching Business Unit is glad to announce Beta release 16.12.2 for all Catalyst 9200/9300/9400/9500/9600 and Catalyst 3650/3850 Platforms. This release is made available to allow users to test, evaluate and share fee...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Do you currently have hands-on networking experience? If you do, we'd love to hear from you!
Your feedback will be reviewed and analyzed by our team to directly influence a networking management and monitoring product.
Take the 20-min or les...