12-06-2021 05:22 AM
I have a 10Gb SFP installed that shows inactive status.
It is just configured for a vlan which is configured on the switch.
Only a handfull of other 10Gb ports in use. Any ideas?
12-06-2021 06:42 AM
To what device the SFP is connected? Does that device support 10Gig?
Can you post:
sh interface x/x
and
sh run interface x/x
HTH
12-08-2021 10:01 AM
Yes it does. Its on one of the 10Gb ports on SUP1 which another active 10Gb is UP and on.
very basic configs
switchport mode trunk
switchport trunk allowed vlan X
12-08-2021 12:01 PM
Try using a different SFP+
12-22-2021 04:51 PM
Yes once I can get I will check and post update thanks again.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
