06-24-2013 06:35 AM - edited 03-07-2019 02:02 PM
Dear All,
I have cisco 4510R with sup6 and iam trying to inistall 1G SFP module on sup 6 and i given the fallowing cmd to change 10g to 1g
cat4500(config)#hw-module module 6 port-group 1 select gigabitethernet.
Core4500#sh hw-module module 6 port-group
Module Port-group Active Inactive
----------------------------------------------------------------------------------
6 1 Gi6/3-4 Te6/1
6 2 Te6/2,Gi6/5-6
now the module is detected and its showing UN-Known sfp
show Interface:
GigabitEthernet6/3 is down, line protocol is down (inactive)
Hardware is Gigabit Ethernet Port, address is 0021.555b.8dc2 (bia 0021.555b.8dc2)
Description: Uplink US-RTN-23L8-6509-1
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, Auto-speed, link type is auto, media type is Un-Known Gbic
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Plaz any suggessions.
Thanks & Regards
Srinivas
06-24-2013 02:02 PM
Are you trying to change an interface speed?
Could you send sh module output command ?
06-24-2013 05:27 PM
I agree first try to negotiate the speed and s duplex settings then update follow by the links mentioend below:-
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/sw_int.html
http://2and2is5.wordpress.com/2011/02/16/configuring-cisco-twingig-converter-modules/
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide